Adjusting The Handle - Flex LRP 1503 VRA Instrucciones De Funcionamiento Originales

LRP 1503 VRA
 Place the sanding belt over the rollers (2.).
`^rqflk>
lÄëÉêîÉ=íÜÉ=ëéÉÅáÑáÉÇ=êìååáåÖ=ÇáêÉÅíáçå=çÑ=íÜÉ=
ÄÉäí>=oìååáåÖ=ÇáêÉÅíáçå=ãìëí=ÅçêêÉëéçåÇ=ïáíÜ=
íÜÉ=~êêçï=çå=íÜÉ=ÖÉ~ê=ÜÉ~ÇK
 Release the rocker (3.).
 Check that the belt is situated fully on the
rollers.
klqb
máéÉë=~êÉ=ã~ÅÜáåÉÇ=ÄÉíïÉÉå=íÜÉ=êçääÉêë=U=
~åÇ NNK

Adjusting the handle

If working in locations which are difficult to
access, e.g. handrails attached to walls,
the handle 2 can be swivelled by 180°.
The minimum distance between the workpiece
and obstacle is 50 mm.
 Pull out the mains plug.
 Open clamping lever (1.).
 Press together the rocker (2.) until the handle
can be swivelled by 180° (3.).
 Close clamping lever (4.).
klqb
qÜÉ=ë~åÇáåÖ=ÄÉäí=áë=åçï=ëä~Åâ=çå=íÜÉ=êçääÉêëK
^ÑíÉê=éä~ÅáåÖ=íÜÉ=ã~ÅÜáåÉ=çå=íÜÉ=ïçêâéáÉÅÉ=
~åÇ=ÄÉÑçêÉ=ëïáíÅÜáåÖ=áí=çåI=ÅÜÉÅâ=íÜ~í=íÜÉ=ÄÉäí=
áë=ëáíì~íÉÇ=Ñìääó=çå=íÜÉ=êçääÉêëK
Belt speed
The belt speed can be adjusted steplessly to
the material requirements with the adjusting
wheel .
17