Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
A
G
H
E
I
C
3
A
I
2
1
Contact Schön at (800) 880-8164 or visit www.schonsimplymodern.com. Copyright ©2015, World Imports Decorative Plumbing. All rights reserved.
1.
Place the metal washers (H), and hex nuts (G) on the floor bolts (E).
Alternately tighten the nuts (G) until the toilet (A) is firmly seated on
the floor.
2.
Pour water into the toilet bowl (A) to prevent the escape of sewer gases.
3.
Place the side caps (I) on the toilet (A) and press in for a secure t.
1.
Using a flathead screwdriver, remove the preassembled screws (1)
from the dual ush push button (C). Removing the screws (1) will
free the U-locking piece (2) from the dual flush push button (C).
2.
Insert the dual flush push button (C) into the top of the tank lid (3)
2
1
with the half flush above the coloured button in the tank. Screw
the U-locking piece (2) back into the dual flush push button (C)
using the screws (1) to secure it on the tank lid (3).
3.
Replace the tank lid (3) on the toilet (A).
1.
Connect the water supply line (not included) between the tank (A)
A
and shut-o valve. Tighten the tank connection coupling nut ¼ turn
beyond hand tight. DO NOT OVERTIGHTEN THE TANK CONNECTION.
2.
Turn on the supply valve and allow the tank (A) to fill.
3.
Check for leakage at all connections and tighten or correct as needed.
1.
Place the toilet seat bolt (I) through the hole (1) on the toilet seat (C).
Position the toilet seat (C) in the desired position, and tighten the
2.
toilet seat bolt (I) from above with a Flathead screwdriver.
B
3.
Cover the tightened bolt with the decorative cap (2).
Repeat this procedure to secure the other side of the toilet seat (B).
4.
1-Piece Dual Flush Toilet
CAUTION
Do not overtighten the hex nuts (G), as vitreous china can easily
crack or chip.
PAGE 5
Installation Instructions
Publicidad
Tabla de contenido
