Cloud Nine CURLING WAND Manual Del Usuario página 6

CURLING WAND booklet_Layout 3 08/02/2017 09:39 Page 6
Using the Curling Wand to create glamorous waves...
•
Always wear the protective glove provided on the hand you use to wind hair around the wand barrel.
•
Plug into the mains power and turn on by pressing and holding the power button down for two seconds. The auto light will
turn blue and the MED light will flash red. The MED light will remain green once the MED temperature is reached. To select
the LOW or HIGH temperatures, press the power switch again until the selected temperature flashes red. The indicator will
turn green once the selected temperature is reached. You can now begin styling.
•
Always use the wand on clean, dry hair.
•
Should you require a higher or lower temperature during styling, press the power button again until the selected
temperature flashes red. The indicator will turn green once the temperature is reached. This allows time for the wand to cool
down or heat up sufficiently.
•
When the wand is in AUTO mode, it will automatically heat to the MED setting when switched on. To change the AUTO
mode to manual, hold down the AUTO button for two seconds, whilst the wand is switched on. The blue AUTO light will turn
off. The wand is now in manual mode and will start on the last used temperature setting when turned on. To return the wand
to AUTO mode, hold down the AUTO button whilst the wand is switched on. The AUTO light will remain blue.
•
Once you have finished styling, turn the power off by pressing the power button for two seconds until the green indicator
light has gone off and unplug from the mains power supply.
•
Never wrap the cord around the wand
•
The wand also has a kick stand integrated into the back of the handle. To use the stand, lift the stand with the tip of your
finger and extend out towards the barrel. Place on a flat surface.
Replace the stand into the handle before styling.
•
Your Cloud Nine wand is supplied with a standard two pin Europlug but has been fitted with a UK 3 pin adaptor. To use your
Wand in a country outside of the UK, simply remove the screw that is positioned between the 3 pins and remove the adaptor
from the 2 pin plug. your Wand in a country outside of the UK, simply remove the screw that is positioned between the 3
pins and remove the adaptor from the 2 pin plug.