Troubleshooting - August SE50 Manual De Instrucciones

To save a channel to the stored channel list, press "MEM" then
use "FM-" or "FM+" to select a channel number then press
"MEM" again to confirm.
Press "VOL-" or "VOL+" buttons to adjust the volume.
7. Audio-In Mode
To use the SE50 as a wired speaker, use a 3.5mm audio cable to
connect the SE50 with your source device. Press "SOURCE" to
select AUX mode, an AUX icon will be displayed on the LCD
screen.
Press "VOL-" or "VOL+" buttons to adjust the volume.
-6-
8. Specifications
LCD Display
Bluetooth Specification
Speakers
Frequency Response
Separation
S/N
FM Radio Frequency
Power Adaptor
Dimensions
Weight

9. Troubleshooting

The problems listed below do not necessarily signify a fault
with the device. Please check this list before requesting a repair.
Problem Possible Cause
No power
Power adaptor plug loose Check power adaptor
Cannot be found SE50 is not in Bluetooth
via Bluetooth pairing mode
No radio No signal
No sound The volume is too low or
the playback is paused
1.4 inch
Bluetooth V2.1+EDR
2 x 15 Watts
80Hz – 20KHz
40dB(1KHz)
70dB
87.5 – 108.0MHz
Input: AC 100~240V 50/60Hz
Output: DC 15V 2A
300 x 95 x100mm
1238g
Solution
plug connection.
In Bluetooth mode, press
and hold the button to
enter pairing mode.
Try repositioning the device
or adjusting the antenna angle.
Try to increase the volume
of the SE50 and your source
device or resume playback on
your source device.
-7-