HON 38210NS Manual Del Usuario página 2

Illustration 4
Main unit
end panel
Skirt
1 / " long
2
mounting
screw
bracket
Illustration 5
Curved
Main unit
edge
Filler strip
Seam
Tapered
end
42-2491K
SIDE 2 OF 2 (1/06)
BRIDGE ASSEMBLY
Main unit
Bridge
Bridge
skirt
Main
unit
Front edge of
bridge top
Main unit
10. Refer to Illustration 4. Use the drill and
to remove / " long screws securing bridge skirt mounting
1
2
brackets to bottom edges of skirt. Save screws and skirt
mounting brackets for later use.
11. Refer to Illustration 4. Place skirt mounting bracket under
main unit end panels as shown.
12. Refer to Illustration 4. Use the drill and
to reinstall / " long screws, removed from skirt mounting
1
2
bracket, through bridge skirt mounting bracket and into
edge of bridge skirt. Do not fully tighten screws.
13. After adjusting the alignment of bridge, use the drill and
power nutdriver to tighten all screws.
14. Refer to Illustration 5. Remove protective backing from
mounting tape on filler strip. With curved edge facing main
unit, align tapered end of filler strip with front edge of
bridge top. Carefully insert filler strip into seam between
main unit and bridge assembly. Repeat this procedure for
remaining bridge seam.
1 / " power nutdriver
4
/ " power nutdriver
1
4
/ "
1
4