Uline ZEBRA GX430T Guia De Inicio Rapido página 3

4. Pull the media so that it extends out of the front of
the printer. Verify the roll turns freely. The roll must not
sit in the bottom of the media compartment. Verify
that the media's printing surface is facing up.
(Figure 3)
Figure 3
1. With the printer open, place a new ribbon roll on the
printer's lower ribbon supply spindles. Rotate the roll
until the notches align and lock into the left side of
the supply hub. (See Figure 5)
Figure 5
Transfer Ribbon
PAGE 3 OF 12
LOADING THE MEDIA ROLL CONTINUED
LOADING THE TRANSFER RIBBON
5. Push the media under both of the media guides.
(See Figure 4)
6. Close the printer. Press down until the cover snaps
closed.
Figure 4
2. Place an empty ribbon core on the printer's take-up
spindles. Rotate the ribbon core until the notches
align and lock into the left side of the take-up hub.
(See Figure 6)
3. The first ribbon take-up core is in the packing box.
Subsequently, use the empty supply core to take up
the next roll of ribbon.
Figure 6
Take-Up Spindles
Media
Guides
0118 IH-3991