IMMOBILISER
Negative logic (the relay switches over when the central unit is armed and +15 ignition is present to allow starting the machine even with a
partially flat battery)
Fig.2
+15
SWITCH PROTECTION
Fig.4
purple
HORN WITH POSITIVE CONTROL – SUBKEY
Fig.6
IGNITION
KEY SWITCH
HORN
CONNECTION M03 SIREN
Fig.8
+12V
fuse
brown/red
FINAL CHECK
When installation is complete and the harness connector has been connected to the alarm central unit, proceed as follows:
1. re-connect the battery of the machine.
2. Turn the machine's ignition key ON and then OFF again
3. 50 seconds later, the immobiliser will automatically arm: the direction indicators flash briefly once, the siren beeps once and the LED starts
to flash very slowly.
4. Disarm the alarm system using the remote control: the direction indicators flash once, the siren beeps once and the LED switches off.
5. Within 50 seconds turn the machine on to check that the connections made are operating correctly.
6. Switch the engine off and turn the machine's ignition key OFF. Arm the alarm system within 50 seconds: the direction indicators flash twice,
the siren beeps twice and the LED flashes, with very brief switches off.
7. During the initial 26 seconds immunity period, do the following tests which should provide a BEEP if they have a positive result:
a. Turn the machine's key ON.
b. Activate any switch protection (opening of the saddle compartment, removal of the firewall, ...)
c. Move the machine to activate its tilt protection.
The timing of the immunity period is reset every time a beep is heard.
8. Once the immunity period is over, the LED flashes with an reversed sequence (long switches off) and the alarm system will be triggered for
one 26 sec. cycle by the activation of any of the protection switches, or by turning the machine's key ON, by moving the machine0: the siren will
produce its distinctive, modulated sound, the direction indicators flash and the horn (if connected) will sound intermittently. Check the engine
immobiliser operates correctly during the alarm cycle.
9. When the alarm system is disarmed, the LED will remain on and the siren will emit a BOOP sound to signal that it has memorised an alarm
trigger: refer to the user manual for the code of this signal and for all other features/settings of the product..
Ignition pack,
coil, petrol pump
C
RELAY
10 AMP
LEGOS central unit
NC
M131
SWITCH
TO BE
INSTALLED
+12V
+12V
ORIGINAL
SUPPLEMENTARY
CONTROL
RELAY
brown
M03
black/red
black
Fig.3
+15
dark blue
IGNITION
KEY SWITCH
Fig.5 If not used, connect the wire to an earth point
yellow/green
HORN WITH NEGATIVE CONTROL – SUBKEY
Fig.7
+12V
IGNITION
P600 DIODES
KEY SWITCH
to be installed
HORN
ORIGINAL
CONTROL
CONNECTION AUXILIARY MODULES
Fig.9
M1603 (OPT)
Omidirectional Lift
and tilt sensor
SUPPLEMENTARY
From the magneto
RELAY
87
30
87/A
86
85
dark blue
C
NC
COIL
RELAY
LEGOS central unit
SWITCH
TO BE
INSTALLED
M131
TO THE ORIGINAL
CONTROLS
DIRECTION
INDICATORS
SUPPLEMENTARY
RELAY
+12V
brown
red
black
pink
purple
dark blue
brown