Pleasant Hearth 23-16-70 Instrucciones De Ensamblaje página 3

Carefully remove all pieces from carton and
Step 1
make sure that you have all parts listed (refer
to parts list on page 1).
If you are missing parts, please call GHP
customer service at 1-877-447-4768.
1. Lay left pilaster (E) on a clean, non-abrasive
surface. Align left panel (G) with pre-drilled
holes in left pilaster (E). Insert 3 bolts (AA)
through flat washers (BB), through pre-drilled
holes in glue blocks of left panel (G), and into
pre-drilled holes in left pilaster (E). Tighten
securely with screwdriver.
Step 2
2. Lay right pilaster (D) on a clean, non-abrasive
surface. Align right panel (F) with pre-drilled
holes in right pilaster (D). Insert 3 bolts (AA)
through flat washers (BB), through pre-drilled
holes in glue blocks of right panel (F), and into
pre-drilled holes in right pilaster (D). Tighten
securely with screwdriver.
Step 3
3. Set bottom panel (B) upright and insert 3
wood dowels (CC) into pre-drilled holes in top
left side of base (B). Slip left side assembly
over wood dowels (CC) through pre-drilled
holes in bottom edge of left assembly. Make
sure both assembly is snug, then secure with
flat washers (BB) and bolts (AA) in pre-drilled
holes as illustrated. Tighten with screwdriver.
Repeat with right side assembly.
2