ZAMST FILMISTA Instrucciones De Uso página 2

How to apply
• Before attaching this product, carefully read through the "Precautions for use - Be sure to read this" section. Then follow the steps provided to
ensure the product is attached correctly.
1.
Unfasten all the hook-and-loop fasteners of the main
body of the product, and check the product's top/
bottom and inside/outside. Confirm the top and bottom
of the product by noting the direction of the arrow on the
tag.
Hook-and-loop fastener A
Tag
Hook-and-loop fastener B
<Inside of the product>
2.
Place the product on the back of your knee while making
sure that the logo mark is at the bottom.
Logo mark
3.
Straighten the knee and fasten hook-and-loop fastener A.
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Hook-and-loop fastener A
4.
Straighten the knee and fasten hook-and-loop fastener B.
5.
Adjust the positions of hook-and-loop fasteners A and
B so that you will be able to maintain an appropriate
compression force.
6.
Straighten the knee and pull the product to eliminate
slack.
7.
Make sure that the product is not loose or incorrectly
attached. If you feel any discomfort, repeat the steps
from the beginning to reattach the product.
If you wrap the product too tightly, you may
feel numbness. Take extreme care.
Hook-and-loop fastener B