Technical Data - Skil 3157 Manual Original

a
Cordless LED work
light
INTRODUCTION
• The worklight is intended for
illumination in dry indoor areas
• This tool is not intended for
professional use
• Read this instruction manual carefully
before use and save it for future
reference 3

TECHNICAL DATA 1

Dimensions (length x width x height) 217
x 209 x 176 mm
TOOL ELEMENTS 2
A Battery level indicator
B On/off switch
C Lock knob
D Hook
E Tripod mount 1/4"
SAFETY
GENERAL
• Handle the worklight with care
• Do not direct the light beam at
persons or animals and do not
stare into the light beam yourself
(not even from a distance)
• Do not cover off the lamp head
while operating the worklight
(the lamp head heats up during
operation and can cause burns
when the heat accumulates)
BATTERIES
• The battery supplied is partially
charged (to ensure full capacity of the
battery, completely charge the battery
in the battery charger before using
your power tool for the first time)
• Only use the following batteries
and chargers with this tool
- SKIL battery: BR1*31****
- SKIL charger: CR1*31****
• Do not use battery when damaged; it
should be replaced immediately
• Do not disassemble the battery
• Do not expose tool/battery to rain
• Permitted ambient temperature (tool/
charger/battery):
- when charging 4...40°C
- during operation –20...+50°C
3157
- during storage –20...+50°C
EXPLANATION OF SYMBOLS ON
TOOL/BATTERY
3 Read the instruction manual before
use
4 Batteries may explode when disposed
of in fire, so do not burn battery for
any reason
5 Store tool/charger/battery in locations
where temperature will not exceed
50°C
6 Do not dispose of electric tools and
batteries together with household
waste material
7 Insulation class III
8 Do not stare into the light beam
USE
• Charging battery
! read the safety warnings and
instructions provided with the
charger
• Removing/installing the battery 2
• Battery level indicator 9
- press the battery level indicator
button A to show the current battery
level 9 a
! when the lowest level of the
battery indicator starts flashing
after pressing button A 9 b, the
battery is empty
! when 2 levels of the battery
indicator start flashing after
pressing button A 9 c, the
battery is not within the
allowable operating temperature
range
• Battery protection
The tool is suddenly being switched
off or prevented from being switched
on, when
- the load is too high --> remove
load and restart
- the battery temperature is not
within the allowable operating
temperature range of -20 to
+50°C --> 2 levels of the battery
level indicator start flashing when
pressing button A 9 c; wait until
battery has returned within the
5