Assembly - HAMPTON BAY 19736-001 Guía De Uso Y Cuidado

ASSEMBLY

1
Installing the tube
Carefully unpack all the parts. Protect the assembly surface
to avoid scratching the lamp or the assembly surface.
Pull out any excess power cord through floor lamp base (A)
during all assembly steps to prevent the cord from becoming
twisted.
Align the holes and insert the tube (B) into the tube (A).
Insert the screw (AA) into the aligned holes, then tighten
the screws (AA) with a allen wrench (BB).
Do not overly tighten screw (AA)"as this may cause
the screw to penetratethe connection point.
Repeat the above step for installing the tube (C).
2
Installing the light bulb
Install one bulb (G) into
19736-001: uses one 100 watt 3-way type A bulb
or LED equivalent.
19273-002: uses one 100 watt type A bulb
or LED equivalent.
NOTE:
NOTE: Do not exceed the maximum wattage.
G
the socket.
or CFL
or CFL
C
B
A
3
Installing the harp and shade
Pinch and insert the harp (D) into the harp tting on the socket
assembly. Slide the caps on the harp (D) over the ttings to
secure.
Remove the nial (F) from the harp (D).
Place the shade (E) on the harp (D) and secure with the nial (F).
F
E
D
C
4
AA
BB