Publicidad
Idiomas disponibles
Idiomas disponibles
Once the machine has been set up properly,
start the engine as follows:
START position by pull it towards the upper
handle and holding it there.
resistance then pull hard untill it starts.
throttle control bar (2) depressed.
release the engine throttle control bar (2).
WARNING:
the engine starts.
Self-Propelled system:
self propelled control bar (3) towards the upper
handle (1)
tle control bar (2)
WARNING: Check the self-propelled system
regularly. Apply grease if necessary.
WARNING: before you adjust the self propelled
cable (13), release the control bar and wait till
the engine stops.
engage correctly, check the handle for correct
assembly. Make sure that all parts are in good
condition and that all the fasteners are tight.
cable (13), is too loose.
cable: turn the cable nut and test the drive system.
ment and test until the drive system does not slip.
system will disengage and that the mower will
stop. If the drive system will not disengage, take
the lawn mower to an authorized service centre
before you operate it.
WARNING: Stop the engine and dis- connect
13
b
the spark plug before attempting any repairs or
maintenance
up if necessary.
that all grass deposits are removed from below
the deck.
larly with wheel bearing grease.
sharp and well balanced blade
and replace if worn.
WARNING: Always wear protective gloves
before checking the blade.
to obtain a crisp cut ensure that the blade is
properly sharpened.
-
blade bolt is still secure.
anced is to stick a metal rod through the centre
hole of the blade; if its balanced it should stay
horizontal. If the blade does not stay horizontal
balance it by taking off some metal on the side
which is down.
-
WARNING: Only use our original spare parts.
Spare parts of a bad quality can cause damage
to your lawnmower and cause harm or injury to
you or bystanders.
check the blade support and change all spare
parts if they are worn out or damaged.
the cutting edge evenly, ensuring its balance.
cutting edges face in the direction of the en-
gine's rotation. The blade screw must be torque
to3.7Kg*m/s2 (37Nm) with a torque wrench.
-
-
Publicidad
