Weidmuller WAVE CONTROL Manual De Instrucciones página 12

1. General instructions
The WAVECONTROL current-monitoring module should only be installed
by qualified personnel. Qualified personnel, as defined in these operating
instructions, are persons considered in 0105 Part 1/DIN EN 50110-1 as
electrically skilled workers or electrotechnically instructed personnel. The
signal conditioner should only be powered up following professional
installation.
Caution! • Electronics units must not be removed from their enclosure
when the voltage supply is connected
• The module must be disconnected from the voltage supply
when configuring the DIP switches on the printed-circuit board
(disconnect the connector from the module)
• Observe ESD regulations
Care must be taken to prevent a direct electrostatic discharge
when setting the DIP switches. Regulations of the county in
which the modules are to be operated are to be observed (for
example, Germany, VDE 0100) when selecting and installing
electrical wiring.
2. Application
WAVECONTROL current-monitoring modules, measure DC, AC and non-
sinusoidal currents up to 60 A, and can be used for monitoring tasks in
diverse areas.
All variables are configured via DIP switches. Further calibration is not
necessary. The measurement circuit is galvanically isolated. Measurement
results are available for further processing as a relay contact or analog value.
All modules are available with pluggable screw or tension clamp connections.
12