Cosatto 3SIXTI2 Manual De Instrucciones página 13

operation
1 - list of parts
Your highchair is supplied in one carton and contains:
1. Inner tray
2. Tray
3. Backrest
4. Seat
2 - attaching the seat to the vertical leg
Fit the five M6 bolts (9) into the five holes in the top of the seat (4). Turn the seat on over so it is
resting on the footrest and the front of the arms. Secure the vertical leg (5) to the underside of the
seat with the five M6 nuts (10) using the spanner (12) supplied.
Once the nuts are fully tightened, the slot at the end of the bolts (arrowed) should be clearly
visible. Inspect the bolts regularly to ensure the nuts have not come loose.
3 - attaching vertical leg to the base
Align the arrows on the rear of the vertical leg and base (6). Push vertical leg into the hole of base.
Ensure the slot and buckle are aligned before inserting.
You will hear a "click" when they are secured into place.
4 - attaching backrest
1. Insert the backrest (3) into the seat. Ensure the recline bar (a) is properly inserted in the hole as
shown in the diagram.
2. Ensure the hooks securely locks to the seat.
3. Insert the seat fixing bar (11) into the backrest securely through the side of seat as shown in the
diagram.
5 - attaching the seat cover
Place the seat cover (7) over the seat and pull down into position.
Fit the seat cover over the crotch post as shown.
6 - attaching and using the harness
A five point harness (8) is provided to restrain your child. To fit the harness, push the butterfly
ends (a) through the slots in the seat cover and seat.
Sliding adjusters are fitted on the waist and shoulder straps (b) and should be carefully adjusted
so the harness fits your child comfortably. To adjust to the smallest size you will need to thread the
adjusters through the "D" ring.
To release the harness push the button in the centre of the buckle (c). To fasten the harness push the
shoulder strap clips onto the waist strap clips (d) then push the waist strap clips into the buckle (e).
'D' rings are fitted at the end of each waist strap should you wish to attach a separate harness
complying to BS EN 13210. The length of each strap can be changed by using adjusters (b).
WARNING: Always use the crotch strap in combination with the waist strap.
7 - attaching the inner tray
The inner tray (1) can be insert or removed by the clip (a) at the rear of the outer tray (2).
8 - attaching the tray
Attach the tray (2) by sliding it down the tracks on the arm of the chair, pull out the handles (a)
simultaneously and lock it into one of the three positions (b, c & d) to best suit your child.
WARNING: The tray is not designed to hold the child into the chair. The
child should be secured in the highchair at all times by the harness.
NOTE: When the tray is in the required position pull it forward to ensure
that it is secured.
5. Vertical leg
6. Base
7. Seat cover
8. 5 point harness
9. M6 bolt x 5
10. M6 nut x 5
11. Seat fixing bar
12. Spanner