IVT CS-185-RC Manual De Instrucciones página 11

restrict the age of the operator.
WARNING!
alcohol, medication and drugs, plus
states of illness, fever and fatigue will
affect your ability to react. Do not use
this tool in any of these situations.
Make sure that all the protective devices (if present) are
fitted and are in good condition.
Never operate the tool with defective safety devices or
guards (if present), or without safety devices in place.
Inspect the entire tool to look for loose parts (e.g.
nuts, bolts, screws, etc.) and for any damage. Check
at frequent intervals if screws and bolts (if present)
are properly tight to be sure the equipment is in safe
working condition. Repair or replace them, if necessary,
before using the tool. Serious injury to the operator and
to the bystanders could result if there's any damage to
the tool.
While using the tool, dress properly. Do not wear loose
clothing or jewellery that could become caught by the
tool. Wear suitable working clothes. It is recommended
that legs and feet are covered, to protect them from
eventual flying debris. Do not work barefoot or wearing
open sandals. Long air should be tided back.
Keep handles and grips dry, clean and free from oil and
grease.
Use proper protective equipment. Use safety glasses
and safety gloves. Also use a dust mask during
pulverulent operations or if exhaust gases are present.
When necessary, use also non-slipping boots or shoes,
hardhat and earplugs. If the noise level exceeds 85
dB(A), ear protection is obligatory.
WARNING! Use personal protective
equipment!
personal
protect your own health and the
health of others and ensure a trouble-
free operation of the tool.
Do not start to use the tool if it is in an inverted position
or it is not in the right working order.
Ensure that you have a good stand, while you operate
with the tool. Keep proper footing and balance at all
times.
Keep work area clean. Cluttered areas invite injuries.
Before use, all foreign bodies must be removed from
the working area, also pay attention to foreign objects
during the operation.
Do not force the tool.
Only work in daylight or sufficiently good artificial light.
The consumption of
Safety devices and
protective equipment
Never operate the tool without good visibility.
Be careful not to drop the tool or hit it against obstacles.
ATTENTION! Stay alert. Watch what you are doing.
Distraction can cause you to lose control. Use
common sense.
Electrical safety rules
ATTENTION! When using electrical tools, the
following safety instructions should be observed to
prevent the risk of electric shock, personal injury
and fire. Read and observe these instructions
carefully before using the tool.
It is recommended for increased electrical safety to use
a Residual Current Device (RCD) with a tripping current
of not more than 30 mA. Always check your RCD every
time you use it. Consult a reliable electrician.
WARNING! The use of an RCD or
other circuit breaker unit does not
release the operator from the safety
instructions
practices given in this manual.
The main voltage must correspond to the one marked
on the labels and on this manual. Do not use other
sources of power.
Before inserting the plug in the main socket, make sure
that the socket ratings are correct and correspond to
those indicated on the rating label on the appliance.
Avoid body contact with grounded surfaces such
as pipes, radiators, ranges and refrigerators. This
increases risk of electric shock if your body is grounded.
CAUTION! Touching electrified parts
may cause death by electric shock or
burn.
Never move the appliance by pulling at the cables.
Do not abuse the cord. Keep it away from heat, oil,
sharp edges or moving parts.
Always guide the connection line safely.
Do not use power tools near flammable liquids or gases.
Always disconnect the appliance from the mains supply
before transporting it to other places.
11
Instruction manual
and safe working
EN