Publicidad
Idiomas disponibles
Idiomas disponibles
PAGE 2 OF 6
ASSEMBLY CONTINUED
C
Figure 3
D
Figure 4
E
Figure 5
4. Connect the two upright post assemblies by inserting
front/back supports (C) at the top and bottom of each
upright post. (See Figure 3)
NOTE: Be sure the supports are fully seated before
continuing with assembly.
NOTE: Front/back supports should be positioned
with ledge on top.
5. Repeat step 4 for installation of the remaining front/back
supports (C).
6. Attach center supports (D) at each level by placing the
keyhole slots (on center support) over the rivets (on the
inside of the front/back supports) and tapping them
into place. (See Figure 4)
7. Set boards (E) on top of center supports, side supports,
and front/back supports. (See Figure 5)
1-800-295-5510
uline.com
1220 IH-5377
Publicidad
