Care And Maintenance - PALSON Geiser Modo De Empleo

GB
In a dangerous setting, the pertinent safety standards must be observed to set the water washer in operation. Using the
water washer in an area where there could be a danger of explosion is prohibited.
Do not inject water into materials containing asbestos or other harmful substances.
Never use liquid containing organic solvent, acid or solvent, including gasoline, paint or oil, whose vapors are extremely
flammable, explosive, or toxic. Furthermore, acetone, acids, solvents, etc are corrosive to the water washer.
In the case of breaking during use greater than two minutes, be sure to deactivate the pressure water washer's power
in order to avoid harm.
WATER PRESSURE WASHER FUNCTIONING (DIAGRAM C)
Its spray wand has two main settings. These settings can be changed when turning the nozzle's adaptor found on the
end of the water wand outlet (6).
Turn the nozzle clockwise for a flat stream or in the opposite direction for a more concentrated stream.
Always be sure that the trigger is closed and the pressure water cleaner is disconnected before changing the nozzle
settings.
WHEN YOU USE THE PRESSURE WATER CLEANER IN HIGH PRESSURE SETTINGS, THE RECOMMENDED
WORK DISTANCE BETWEEN THE NOZZLE AND THE OBJECT OR SURFACE TO CLEAN IS 30 CM.
IT MAY BE LESS IF REQUIRED FOR PATIOS OR MASONRY.
Aim the wand towards the object to be cleaned, ensuring that the recommended work distance is maintained. Tighten
the wand's trigger until the water begins to flow. Then activate the pressure water washer.
The pressure water washer stream is capable of carrying out the majority of the cleaning tasks for gardening or construction
but the use of detergent is advantageous when vehicles are cleaned or other paint finishing are carried out.
INSTRUCTIONS FOR DETERGENT USE (DIAGRAM E)
1. Remove the receptacle from the detergent, fill it completely with soap or detergent and put it in the machine again.
2. Remove the pistol's safety.
3. Tighten the trigger to set the machine in operation.
4. Turn the start switch to the "I" on position.

CARE AND MAINTENANCE

WARNING
The high pressure hose connection is a very important part of the pressure water washer. Use the manufacturer
supplied hose and always try to connect it firmly to the washer. Also try to assemble the pistol wand in a safe manner.
In the case of the pistol's abnormal operation, loss of water, hole in the hose, etc., washer operations must be stopped
immediately and it must be taken to the closest Authorized Technical Service.
The washer is equipped with a safety valve that frees pressure in case of overpressure in the circuit. In case this valve
enters into the operations, do not touch it. Do not handle or disassemble such valve.
The water washer must be deactivated and disconnected from the electrical outlet before cleaning, maintenance, and
replacement of its components. Repairs should be carried out only at the authorized Technical Service.
In order to guarantee an extended useful life and use without problems from the pressure water washer, we strongly
recommend carrying out regular maintenance in the following manner:
Nozzle: visual check to see if the nozzle is blocked by sand or dirt. If so, remove the dirt with the provided cleaning tool.
Then rinse with clean water on the outside.
Water connection: After approximately 30 minutes of running, remove the filter in line with the water intake (2) (DIAGRAM D)
and check for obstructions. If there are any, flush out and clean the filter.
IMPORTANT
Note that frost may damage your pressure washer if it has not been fully emptied of water after use. Always keep it in
a location protected from frost.
TROUBLESHOOTING
If you have a problem, first check the following table.
If the methods indicated cannot solve the problem, bring the water washer, packaging, and stamped warranty to the
retail store or Authorized Technical Service to get help.
14