Publicidad
Enlaces rápidos
AUTOMOTIVE PRODUCTS, INC.
MOUNT KIT
EQUIPO DE MONTAJE
TROUSSE DE MONTAGE
22-1335
CHROME/
CROMADO
/CHROME
22-0000, 22-0030, 22-5000, 22-5035
BLACK/NEGRO/NOIR
22-0005, 22-0035. 22-5005, 22-5035
ITEM
QTY
1,2
2
STEP BAR,
3
2
FRONT BRACKET
4
2
REAR BRACKET
5
16
5/16-18 X 1.00" HEX HEAD BOLT
6
16
5/16" SAE FLAT WASHER
7
8
5/16" USS FLAT WASHER
8
16
5/16" LOCK WASHER
9
8
5/16-18" HEX NUT
10
8
EXTRUDED U-NUT
11
8
1/4-20 X .75 T-HEAD BOLT
12
8
1/4" FLAT WASHER
13
8
1/4-20 NYLON INSERT LOCK NUT
1,2
2
ESTRIBOS, LADO DEL ACOMPAÑANTE (1) Y EL CONDUCTOR (2) (SE COMPRA
SEPARADO)
3
2
SOPORTE DELANTERAS
4
2
SOPORTE TRASERAS
5
16
PERNOS CON CABEZA HEXAGONAL 5/16-18 X 1.00"
6
16
ARANDELA PLANA SAE DE 5/16"
7
8
ARANDELA PLANA USS DE 5/16"
8
16
ARANDELAS DE PRESIÓN DE 5/16"
9
8
TUERCAS HEXAGONALES DE 5/16-18
10
8
TUERCA A PRESIÓN EN "U"
11
8
PERNOS CON CABEZA EN T DE 1/4-20 X .75"
12
8
ARANDELAS PLANAS DE 1/4"
13
8
TUERCA DE FIJACIÓN HEXAGONAL 1/4-20
1,2
2
MARCHE-PIEDS, COTE PASSAGER (1) ET COTE CONDUCTEUR (2) (ACHETE
SEPAREMENT)
3
2
SUPPORTS AVANT
4
2
SUPPORTS ARRIERE
5
16
BOULONS A TETE HEXAGONALE 5/16-18 X 1,00 PO
6
16
RONDELLES PLATE SAE 5/16 PO
7
8
RONDELLES PLATE USS 5/16 PO
8
16
RONDELLES A FREIN 5/16 PO
9
8
ÉCROUS HEXAGONAUX 5/16-18
10
8
ECROU EN U EXTRUDE
11
8
BOULONS A TETE-T 1/4-20 X .75 PO
12
8
RONDELLES PLATES 1/4 PO
13
8
1/4-20 ÉCROU DE BLOCAGE SIX PANS
STEP 1.
Remove contents from box and check for damage. Verify all parts are present. Read instructions completely before
beginning.
STEP 2.
Remove black tape and large rubber grommets over mounting holes located on the inside face of rocker panel.
STEP 3.
Install front and rear brackets as shown. Hand tighten.
NOTE:
Rear bracket is 1/2" longer than front bracket.
STEP 4.
Slide T-head bolts on step bar as shown (2 per slot, 4 per bar). Place step bar on saddle with long step pad forward and
end cap screw facing inward. Assemble with 1/4" fasteners.
Make sure step bar and brackets are properly aligned and tighten fasteners. Recommended torque values are 15 FT.LBS
STEP 5.
for 5/16" fasteners and 7 FT.LBS. for 1/4" fasteners.
FINISH PROTECTION
Westin products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect the finish with a non-abrasive automotive wax, (e.g.
Pure Carnauba) on a regular basis. The use of any soap, polish or wax that contains an abrasive is detrimental, as the compounds scratch the finish and open it to
corrosion.
INSTRUCTIONS-INSTRUCCIONES-CONSIGNES
APPLICATION:
APLICACIÓN:
APPLICATION: 2004-07 FORD F-150
2
CONTENTS -
CONTENIDO
PASSENGER (1) AND DRIVER (2) PURCHASED SEPARATELY
2004-07
FORD F-150
2006-07 LINCOLN MARK LT
FORD F'150 MOD. 2004-07
LINCOLN MARK LT 2006-07
2006-07 LINCOLN MARK LT
1
- CONTENU
SEE FIGURE 1.
SEE FIGURES 2 AND 3.
WO:
3
4
TOOLS -
HERRAMIENTA
9/16" SOCKET
1/2" SOCKET
10MM SOCKET
10MM WRENCH
RATCHET
TORQUE WRENCH
DADO DE 9/16"
DADO DE 1/2"
DADO DE 10MM
LLAVE DE TUERCAS DE 100MM
MANERAL
LLAVE DE TORQUE
DOUILLE 9/16 PO
DOUILLE 1/2 PO
DOUILLE 10MM
CLEF 10MM
CLIQUET
CLEF DE COUPLE
75-0660 REVISION C 4/13/07
- OUTILS
Publicidad
Manuales relacionados para Westin 22-0000
Resumen de contenidos para Westin 22-0000
- Página 1 FINISH PROTECTION Westin products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect the finish with a non-abrasive automotive wax, (e.g. Pure Carnauba) on a regular basis. The use of any soap, polish or wax that contains an abrasive is detrimental, as the compounds scratch the finish and open it to corrosion.
- Página 2 PROTECTION DE LA FINISSION Les produits Westin ont une finission de haute qualité qui requiert des soins, comme toute autre finission du véhicule exposée aux éléments. Protégez la finission à l’aide d’une cire non-abrasive (par exemple, Pure Carnauba) de façon régulière. L ’usage de tout savon, pâte à polir ou cire contenant un abrasif est nuisible, puisque les composantes strient la finission et la laissent vulnérable à...