Knape & Vogt HM-25-G Instrucciones De Instalación

Wire 1/2 moon (1)
Parts Included
A. Half-moon shelf assembly
B. Side C-Hinge
C. Pin and plastic washers
D. L-bracket, screw and nut
E. Mounting screws
A
D
Tools Required
• Phillips head screwdriver
• Drill with 1/16" bit for pilot holes
Product
Assemblies:
HM-25-G
HM-28-G
HM-34-G
KNAPE & VOGT MANUFACTURING COMPANY
P.O. Box 191, Muncie, IN 47308
0.899.6535 • 765.288.8730 • Fax 765.288.0851 • www.kv.com
Step 1 Locate cabinet side for attaching half moon susan
Step 2 The L-bracket performs as a stop for the slides. The
E
Step 3 Position plastic washers over
B C
WIRE HALF MOON
GLIDE-OUT LAZY SUSAN
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
shelf. Wrap the C-hinge around the cabinet frame so
the tabs hold the pin inside the cabinet. Screw C-
hinge into place using two long screws in the side
of the cabinet face frame, and 4 short screws into
the back of the cabinet face frame.
placement of the L-bracket on the slides is opposite
the cabinet door opening. Position bracket on small
slide member, align holes and fasten in place using
small round head screw and nut.
holes in the C-hinge. These
will ensure smooth operation
during shelf pivot movement.
Align the holes on the
bracket of the half moon
shelf assembly with the
holes in the C-hinge. Slide
pin through all four holes
from the top downward.
Door
Place "L"
bracket here
Top view of cabinet
Tab
Short
screws
Long
screws
step 1
step 2
Pin
Basket
hinge
bracket
Washer
step 3
RN-260EFS 04/03