Plantronics HL2 Manual Del Usuario página 7

TELEPHONE HANDSET LIFTER SYSTEM
GB
The HL2 telephone handset lifter system is a mechanical handset
lifter designed for use with the A20 telephone headset amplifier
and accessory deck
PUTTING THE HL2 TOGETHER
Remove the parts of the HL2 from their packaging. Place the Accessory Deck (13)
of the A20 Amplifier into the Lifter Motor (2). These parts lock together easily.
Remove the Accessory Deck Cover (23) from the Accessory Deck (13) of the
A20 Adapter.
If you have already assembled your A20 Amplifier, disconnect the On Line
Indicator (OLI) (15) from the Accessory Port (19) of the A20.
Connect the HL2 Cable (1) to the Accessory Port on the base of the A20 (19).
Feed the cable through the guide channels in the base of the A20.
Connect the On Line Indicator (OLI) (15) to the On line Indicator Port (6) at the
rear of the HL2 lifter. Replace the accessory deck cover (23).
Lift your telephone, and position squarely on the Accessory Deck (13). The base
opens out to accommodate larger telephones. (See diagram D in A20 user guide.)
Once your telephone is in position on the Accessory Deck (13), slide the Lifter Arm
(3) into the Lifter Arm Holder (4) on the HL2 Lifter Motor. The Lifter Arm needs to
be positioned so that it will sit in the cavity under the telephone handset. To
tighten the Lifter Arm once it is in the correct position, use a coin to rotate the
Lifter Arm Screw (see diagram C).
Next, hold the Lifter Arm and either raise or lower it manually to fit under your
handset while it is in its cradle. The arm needs to be underneath the handset in
order to raise it and answer the phone. You will encounter some resistance to
moving the Lifter Arm, however, you cannot damage the device by making
this adjustment.
No other connections are required. The HL2 is powered by the A20 Base Unit.
(Numbers in black) denote the key from the A20 Amplifier user guide.
5