Before Installation; Installation Instructions - G-U DS-40 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before installation:

1.
The supplied batteries must be inserted before starting the
installation.
2.
Loose the screw on the bottom of the digital door viewer, remove
the support plate and the plastic film from the back of the support
plate. The support plate can now be installed.

Installation instructions:

1.
Replace the existing door viewer or drill a 14 mm hole in the door
at the required height. Peel off film and then insert the camera
from the outside. Ensure the doorbell button is under the camera
and adjust the camera vertically to the floor level (Fig. 1).
2.
Peel off the 3M film on the support plate and place the support
plate over the end of the camera cable on the inside of the door.
Make sure the arrow on the support plate points upwards. Then
screw the locking barrel on the back of the camera. This will hold
the plate to the door (Fig. 2).
3.
When inserting the camera cable into the socket, ensure you
match the connectors correctly. (If inserted the wrong way, this
can damage the wires of the camera). The excessive cable should
be gently placed into the groove at the back of the screen.
4.
Hook the screen over the bracket at the top of the support plate
and secure with one small screw through the hole at the bottom of
the screen case (fig. 3).
12

Publicidad

Tabla de contenido
loading

Tabla de contenido