Publicidad
INSTALLATION
• You should make the tube clear through compressing
the air before installation.
• The product should be vertical in position and make
the water cup and oil cup down.
• Please note the flowing direction of compressing air.
The direction of arrowhead on the model is same as
the flowing direction of compressing air.
• The end of "IN" on the model gets into the air; and
the other end gets out the air.
MATERIALS
Base
Cup
Cup's shell
Cup's o-rings lock
Diaphragm
CAUTIONS
Avoiding the vertical shining.
DO NOT USE THIS MATERIALS WITH
POLYCARBONATE:
Acetone Chloroform
Acid Acetic Cresol
Acid Formic Diamina
Acid Hydrochloric ether ethyl
Acid Nitric Freon
Acid Sulfuric Phenol
Acid ethyl Gasoline
Acid Isopropyl Hydroxide de Ammonia
Acid Metallic Hydroxide of Sodium
Ammoniac oil to hydraulic brake
Anhydride Acetic Azonic
Aniline per chlorine ethyl
Benzene Tetra chlorine of Carbon
Carbonate of Ammonium Thinner
OPERATION
Drainer:
The drainer of these series is half automatic. It can drain
automatically when the air stopped.
You should drain periodically if the products work
continuous and long time and drain water one most
per team.
Avoid to excess de level. You can push up the nut with
pattern un the end of AF or AW. It is over. You can relax
the nut and it will be closed.
Regulate pressure:
You should check the supply pressure before you
regulator the pressure the supply pressure should be
more by regulation pressure.
When you regulates the pressure, please first pull out
the handle the pressure. Will be up if you rotate the
handle with the direction of "+". The pressure will be
down. if you rotate the handle with the direction of "-".
When the regulator is over, you can push the handle
to the old place and the handle will be locked to avoid
changing the regulated pressure.
The oil:
It's used for recommended oil is turbine oil CLASS1
ISO VG32 . Spindle oil is forbidden, the oil should be
kept between the up end and down end, please note
supplying the oil in time. See add information.
Zamac
Can be supplemented oil on the condition of not
Polycarbonate
stopping the air. If you wonder to add oil, you should
Transparent
open the nut on the AL and add oil into the mouth of
oil cup. It is over please close the nut again.
Steel
Plastic
Adjust the volume of oil:
The volume of oil can be adjusted with the condition
Nitric rubber
of working. If you rotate the pole with the clock wise,
then the oil will be more. And the oil will be less against
clock wise till to zero.
Dismantle cup:
When you dismantle the water cup oil cup and shell. At
first you should make the pressure clear.
Some series have metal shell. At first you should push
up the shell hardworking the grasp the shell firmly and
press the boll with big toe. The same time you should
rotate the shell to 45° left or right, it means the" II " on
the model and " II "on the shell will be right, this time
you can pull down the shell hardworking, so the cup
and shell will be dismantled.
CLEANING
You should clear the cup and filter periodically, when
you clear cup. Please use middle clear dose and please
make filter dry before you use it.
See all materials that you have to avoid to use with
polycarbonate.
E N G L I S H
3
Publicidad
