System Build 7014500COM Manual De Instrucciones página 18

STEP 11
9
(x40)
Assure that the unit is square.
Distance from corner to corner
must be equal as shown.
systembuild.com
IMPORTANT! THE BACK PANELS ARE A STRUCTURAL PART OF THIS UNIT
AND MUST BE INSTALLED PROPERLY.
Carefully turn the cabinet over on it's front side.
Position upper back panel as shown. Align squarely with outer edges.
Flush bottom edge of upper back panel with bottom edge of shelf (H)
and nail straight into back edges of left panel, right panel, top.
Position lower back panel as shown. Align squarely with outer edges.
Flush bottom edge of lower back panel with bottom edge of bottom
(G) and nail straight into back edges of left panel, right panel, bottom
and shelf.
raw
surface
L
B
H
raw
surface
M
18
9
G
Flush the bottom edge of the
Lower Back Panel with the
bottom edge of Bottom (G).