Hauck Roll A Round II Instrucciones Para El Uso página 9

INStALLAtIoN
GB
Picture 1: Part list
Picture : Setting it up
Set the baby walker up by grasping the upper part of the table and pull it up to the
highest position. the height is adjustable to 3 positions.
Picture 3: Wheels
Place the baby walker upside down on a flat floor, press the wheels with the plastic pins
into the mounts until they click in. Make sure all the wheels are firmly in place.
Picture 4: operate the Stopper
the baby walker can be fixed to the floor by using stopper. to do this, pull out the
4 stoppers underneath the plastic base (4a). Ensure all stoppers are firmly pull out
before putting the baby in (4b).
Picture 5: Seat attachment
to fasten the seat attachment, press the seat unit down to the walker as shown in the
picture. You can turn the seat unit to adjust to the correct position for the child. Do
check the seat is firmly in place before you put your child into the baby walker.
Picture 6: fixing the toys
Press the  unassembly toys into the  corresponding slots and turn to secure in place.
Picture 7: Assembly the toy compartment
7a: detached the  screw caps (in red color) underneath the electronic toy
compartment.
7b: put the electronic toy compartment onto the top tray of baby walker
7c: adjust the toy compartment's position on top tray, so that the  red screw caps can
fix the toy compartment through the bottom of top tray. Use only  x 1.5V R6 batteries,
check polarity when inserting the batteries.
Picture 8: Adjustor
the adjustor is placed underneath the top tray of the baby walker. Pull the button
downward and slid the adjustor forward to adjust the height position. Don't adjust the
position when the child is inside the baby walker.