Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Switch the WATTAGE SELECTOR SWITCH to your desired heat settings:
THERMOSTAT SWITCH:
1. Turn the thermostat Switch clockwise to the highest position to start heater. Allow
heater to operate and warm up the room.
2.
When the desired temperature/comfort
level is reached, lower the temperature
setting by turning the Thermostat Switch
counter-clockwise until the heater stops
operating.
3.
The Thermostat will no automatically
maintain the pre-set temperature level
by turning the theater ON and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset
temperature. To prevent the unit from cycling, raise the temperature setting.
CARE AND MAINTENANCE
WARNING: Do not attempt to disassemble this product for any reason, as incorrect
re-assembly could cause a risk of fire or electric shock. Only qualified service personnel
should perform any servicing.
WARNING: Always unplug the product from the electrical outlet and allow it to cool
before cleaning or storing it.
NOTICE: This product is permanently lubricated at the factory before shipping and will
not require further lubrication for the life of the product.
Clean only the exterior surface by wiping with a soft, damp cloth, and allow the product
to dry completely before storing or using. Dust can be removed from any vents using a
small vacuum.
WARNING: Do not allow water or other liquids to enter the interior of the product.
NOTICE: Do not use abrasive cleaners/pads to clean the product.
To store, wind and secure the power cord using a twist tie or rubber band, and then
place the product in a cool, dry location.
Low Heat (750W): the heater will run continuously at 750W
High Heat (1500W): the heater will run continuously at 1500W
The POWER INDICATIOR will remain lit during operation.
E-5
Publicidad
Tabla de contenido
