LBX instruments Orb-B Manual Del Usuario página 5

4. Function
4.1.
Control
Speed
display
Mode
Time
switch
display
button
5. Operation
• Place the instrument in safe and stable surface, ensure the required operating voltage and p o w e r s u p p l y voltage
matched.
• Connect the power cable.
• Install the platform.
• Switch ON the instrument.
• The instrument begins self-checking
• When initialization is over, LED displays the last running values of speed and timer.
• Rotate the speed control knob clockwise to set target speed:
a) Press the mode switch button to choose the speed or timer setup interface. When the character of LED display is flashing,
rotate the parameter adjusting knob to ser the target parameter. Press the knob to start the motion.
b) During operation, motion can be stopped at any time by pressing the parameter adjusting knob. If the knob is pressed
again, motion will start again and the timer will continue to countdown. When the timer reaches zero, the unit will be
automatically halted
c) When the timer is set to be 00:00, it will run continuously.
• Switch OFF the instrument.
If these operations above are normal, the instrument is ready to operate. If not, the instrument may be damaged during
transportation, please contact technical support of manufacturer/supplier.
Note:
The speed value can be altered during shaking.
Shaking table
Parameter
Mode switch button
adjusting knob
Parameter adjusting
knob
Speed display
Time display
Power switch
Screw
Screws
Power switch
Power interface
Items
Shift speed and time setup mode
Set speed and time by rotating the
knob. Push on/off to start/stop
rotating function
Display the set speed values
Display the set time values
Switch ON/OFF instrument.
Install the platform.
Table 3
5
Descriptions