Uline H-9472 Guia De Inicio Rapido página 2

4. Set the unit where it won't get covered with dust
when drilling the mounting holes.
5. Using a 3/16" drill bit, drill a hole through each pencil
mark.
6. Insert the plastic screw anchors (included) into the
holes. Tap the screw anchors gently with a hammer,
if necessary, until they are flush with the ceiling or
wall.
7. Install the screws but do not tighten completely.
Attach the mounting bracket by aligning the screws
in the open portion of the universal mounting slots
and rotating the bracket into place. (See Figure 2)
Tighten the screws, using a flathead screwdriver,
until they are snug to secure the bracket (D). Do not
overtighten.
Figure 2
Screw
Mounting
Bracket
8. Activate the battery. Mount smoke detector to
mounting bracket to activate. Once unit is activated,
it cannot be turned off.
NOTE: After activating the battery, the power
indicator light may flash. (See Figure 3) If the
unit alarms, the light will blink rapidly, and the
horn will repeatedly sound three beeps, pause,
three beeps. Once the smoke detector is on
the bracket, rotate it to adjust the alignment.
PAGE 2 OF 9
INSTALLATION CONTINUED
Screw
D
9. Press the test button to test the smoke/CO detector.
(See Figure 3)
Figure 3
10. After 10 years of operation or low battery warning,
deactivate the smoke detector. Insert a tool below
edge and break tab. Slide activation switch to
deactivate mode.
IMPORTANT! At end of life or low battery
indication (chirp), unit must be put into
deactivation mode to deactivate remaining
stored energy in battery. Unit will resist
remounting.
LOCKING FEATURE (OPTIONAL)
1. The optional locking feature is designed to prevent
unauthorized removal of the detector. It is not
necessary to activate the lock in single-family
households where unauthorized detector removal is
not a concern.
2. The feature uses a locking pin which is molded into
the mounting bracket. Remove locking pin by using
needle-nose pliers or a utility knife.
IMPORTANT! To permanently remove the
locking pin, insert a flathead screwdriver
between the locking pin and the lock and pry
the pin out of the lock.
Test Button
Power Indicator
Light
0721 IH-9472