Assembling; Operating; Oscillation; Cleaning - G3 Ferrari OSTRO Instrucciones De Uso

ASSEMBLING

The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the
maximum safety, perform the installation completely before operating.
1) Insert the base (14) in the detachable base (11), as shown in the figure.
2) Joint the appropriate clips and stop the two sides with the supplied screws (12).
3) Place the rear grid (5) near the plastic motor protection (15) with the metal handle
facing upwards. Fit the holes present in the central part of the grid with the pins in the
plastic protection (15) and lock the two parts with the stopper (4).
4) Insert the fan (3) into the shaft (6) and screw the cover of the fan (2) to the threaded end
of the drive shaft. Remove the fixing screw (16).
5) Place the front grid (1) in front of the rear grid (5) matching the holes on the grids.
6) Close the locking pins and fasten the two grids tightening the securing screw (16) previously removed.
The fan installation is now complete.

OPERATING

Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical
outlet. By using the control panel (10) the rotation power can be adjusted on different speeds.
- 0: fan is OFF
- 1: low speed
- 2: medium speed
- 3: high speed

OSCILLATION

The oscillation of the head is only possible when the fan is turned on and it can be activated by pressing the
pin (7) downwards until it locks. Lifting the pin (7) until the locking function is disabled. It is recommended
to enable or disable oscillation of the fan only when the unit is off.

CLEANING

Disconnect the plug from the electrical outlet before attempting any cleaning operation.
Do not immerse the unit in water. In any case prevent splashes of water or other liquids reaching the motor
body. Do not clean the unit with metallic sponges or abrasive cleaners, only use neutral detergents and a soft
cloth moistened with water to clean the outer parts.
Dry the product completely before operating the unit.

TECHNICAL FEATURES

•
Power supply: AC 230V
•
Fan diameter: 30cm
•
3 operation speeds - Oscillation
PORTUGUÊS: ADVERTÊNCIAS
As indicações seguintes são muito importantes no que se
refere à instalação, uso e manutenção deste aparelho;
conserve com cuidado este manual para eventuais futuras
consultas; utilize o aparelho apenas do modo indicado
neste manual de instruções; outro tipo de utilização
~
50Hz. Max input power 35W
10