Fixman 211834 Guia De Instalacion página 5

Part 1a Stud Wall Mounting
Level the Wall Plate (1) and use as a template, marking four mounting holes along the centre lines of the wood studs. Drill four 3/16
(4.5mm) diameter holes, 2" (50mm) deep. Level the Wall Plate and attach to the wall using the four Lag Screws (A) and four Washers (F).
Tighten Lag Screws firmly but do not over tighten.
Stud finder
Wood stud
Part 1b Concrete or Brick Wall Mounting
Level the Wall Plate (1) and use as a template, marking four mounting holes on the concrete or brick surface.
NOTE: If attaching to a brick wall, do not drill in to soft mortar. Always drill in to the brick or concrete block and avoid using hammer mode
while drilling through plaster layer.
Drill four 7/16 (10.5mm) diameter holes, 2" (50mm) deep. Vacuum out the holes after drilling. Insert four Masonry Anchor Plugs (H) into
the holes and secure levelled wall plate with four Lag Screws (A) and four Washers (F). Tighten screws firmly but do not over tighten.
Make sure holes are not oversized.
E-G
A
Concrete/brick wall
H
2" (50mm)
3/16" (4.5mm) dia
2" (50mm)
7/16" (10.5mm) dia
E-G
A
www.fixman.co.uk 5