SPX 5093 Instrucciones De Funcionamiento página 3

Parts List & Operating Instructions
1. Remove the base cover.
2. Remove the zinc-coated rod "A," and connect the blue plastic
tube (supplied).
Note: Disengage the trigger lever to lock the handle in one of
four positions:
1. collapsible for transport and packing
2. storage position
3. displacement position
4. working or horizontal position
3. Place the handle in Position 4, insert the bolt and washer near
the bottom of the handle assembly, and insert the floor stop to
the under side of the handle plate (see Figure 3).
4. Replace the base cover.
© SPX Corporation
Setup
Base Cover
3
4
Form No. 107273
Figure 1
2
Figure 2
Floor Stop
Bolt and Washer
Figure 3
Sheet No.
Issue Date: Rev. D, July 25, 2005
"A"
1
2 of 3