Declaration Of Conformity - Ribind TAG READER Manual Del Usuario

TAG 999
Diagram of terminal strips and keys
Note: Make sure that terminals 5 and 7 are bridged in order to enable the relay output. This contact is particularly useful to enable, for instance, the
relay output of the TAG999 via external devices such as buried magnetic coils (TAG999 enabled only in case of a vehicle being present on the coil so
as to avoid undesired operations caused by accidental radio transmission) or via timed relays (TAG999 enabled within a given time interval), as well as
for closing the normally open contact of a switch, and so on.
Note: The input to force the activation of the single door (terminal 6) is active if referred to GND.

DECLARATION OF CONFORMITY

Hereby, RIB S.r.l., declares that TAG999 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
The complete declaration of conformity is available in RIB.
ENGLISH
1 Antenna
2 Relay - N.C. contact
3 Relay - Comman contact
4 Relay - N.O. contact
5 Relay enabling
6 Relay activation (REX)
7 GROUND
8 IWiegand data input (DATA1)
9 IWiegand data input (DATA0)
10 External reader power supplì (9Vdc)
11
Power supply (12-24 VAC/DC)
12
GREEN: VAL (Confirm)
RED: DEC (Decrement location)
BLUE: INC (Increment location)
YELLOW: FUN (Access to function menu)
9