VonHaus 2500259 Manual Del Usuario página 4

instructions to operate the Breaker.
Locate the power tool out of reach of children, in a dry,
locked unit.
Make sure that the cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to damage
or stress.
Remove the plug from the mains socket / battery (where
applicable) before carrying out any adjustment or
maintenance.
Always store the power tool/machine in a dry place.
If the power cord is damaged, it must be replaced by a
qualified service technician.
Keep the ventilation slots and motor housing as free of dirt
and dust as possible (where applicable).
Clean the power tool/machine by rubbing it with a clean
cloth and blow it clean using low-pressure compressed air is
recommended.
Ensure you have all the pieces listed. If you are missing any
components, contact our customer services department at
hello@domu.co.uk (UK/EU) usasuport@domubrands.com
(US). DO NOT proceed with assembly if any components
are missing.
HAND HELD HEDGE TRIMMERS
Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power
tool's operation.
Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to bind
and are easier to control.
Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord. Cutting accessory
contacting a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an electric
shock.
Keep hands away from cutting area. Never reach underneath
the workpiece for any reason. Do not insert fingers or thumb
into the vicinity of the blade and blade release switch.
BATTERY WARNINGS (INCLUDING BUTTON CELLS, AA
BATTERYS, LITHIUM PACKS)
WARNING The use, and particularly abuse of portable
sealed secondary lithium cells and batteries may result in the
creation of hazards and may cause harm.
Do not dismantle, open or shred secondary cells or batteries.
Keep batteries out of the reach of children.
NOTE the battery pack is not fully charged out of the box.
Secondary cells and batteries need to be charged before
use, always refer to the cell or battery manufacturer's
instructions and use the correct charging procedure.
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type of
battery pack may create a risk of fire when used with another
battery pack.
Use the appliance/power tool/machines only with specifically
designated battery packs. Use of any other battery packs
may create a risk of injury and fire.
First read the safety instructions and then follow the charging
notes and procedures.
Incorrect reassembly may result in a risk of electric shock
or fire.
Protect the battery and charger against water and moisture.
Always keep cells and batteries clean and dry.
Wipe the cell or battery terminals with a clean dry cloth if
they become dirty.
Protect the battery from heat and fire. Place the charger in
a position away from any heat source and avoid storage in
direct sunlight.
Do not maintain secondary cells and batteries on charge
when not in use.
After extended periods of storage, it may be necessary to
charge and discharge the cells or batteries several times to
obtain maximum performance.
Do not short-circuit a cell or battery.
Do not store cells or batteries haphazardly in a box or drawer
where they may short-circuit each other or be short-circuited
A5P | 01
by conductive materials. When the battery pack is not in
use, keep it away from other metal objects such as paper
clips, coins, keys, nails, screws or other small metal objects
that can make a connection from one terminal to another.
Short-circuiting the battery terminals together may result in
burns or a fire.
Do not expose cells or batteries to mechanical shock.
Never attempt to open the battery pack for any reason or
if the plastic housing of the battery pack breaks or cracks,
immediately discontinue use and do not recharge.
When possible, remove the battery from the appliance/power
tool/machine when not in use.
Do not leave a battery on prolonged charge when not in use
or stored for extended periods of time as this may cause
damage to the battery.
To facilitate cooling of the battery pack after use, avoid
placing the charger or battery pack in a warm environment
such as a metal shed or an uninsulated trailer.
To reduce the risk of electric shock, unplug the charger from
the outlet before attempting any cleaning. Removing the
battery pack will not reduce this risk.
In the event of a cell leaking, do not allow the liquid to come
into contact with the skin or eyes. If contact has been made,
wash the affected area with copious amounts of water and
seek medical advice.
Seek medical advice immediately if a cell or battery has been
swallowed.
Always observe the polarity marks (+) and (-) on the cell,
battery and equipment and ensure correct use.
Retain the original cell and battery literature for future
reference
When disposing of secondary cells or batterie, keep cells or
batteries of different electrochemical systems separate from
each other.
Do not use any cell or battery which is not designed for use
with the equipment.
Do not mix any cells of different manufacturers, capacity, size
or type within a device.
Always purchase the battery recommended by the device
manufacturer for the equipment.
ADDITIONAL SAFETY INFORMATION FOR BATTERY
CHARGERS.
This appliance should not be used by children and/
or persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge. Children
shall not play with the appliance.
Do not place any object on top of the charger or place the
charger on a soft surface that may result in excessive internal
heat.
Do not attempt to disassemble the charger. Take it to an
electrician or tool repairer when service or repair is required.
Appliances/power tools/machines with Lithium-ion batteries
shall only be charged with the specifically designed Lithium-
ion battery charger purchased with this tool. Do not attempt
to charge the battery with any charger other than the one
supplied as this is potentially dangerous.
Before using the charger, read all instructions, labels and
cautionary markings on the charger.
The charger is not intended to be used for any purpose other
than charging the battery pack for this tool. Any other use
may result in risk of fire or electric shock. Do not attempt to
use the charger on any other voltage or rating than those
stated on the rating plate.
Do not use the charger for any purpose other than that for
which it is intended.
Do not use the charger to charge any device other than the
appliance/power tool/machine it was sold with.
Do not use an extension cord unless absolutely necessary.
The use of an improper extension cord could result in fire or
electric shock.
Never attempt to connect two chargers together.
Use the battery charger indoors only.
Make sure that the charger cable is positioned where it will
not be stepped on, tripped over or otherwise subjected
to damage or stress. Keep the cord away from operating
appliance/power tool/machine.