Inserting The Battery - LaserLiner RangeXtender RX 30 Manual De Instrucciones

Inserting the battery

1
RangeXtender RX 30
–
+
Working with the laser receiver RX
2
Use the laser receiver RX for levelling over longer distances or when the
laser lines are no longer visible. Switch on with button F; control lamp G
will light up.
Line lasers:
RX 30 / RX 52:
RX 51:
Set the line laser to hand receiver mode. The laser lines will now pulsate with
high frequency, making the laser lines darker. The laser receiver can detect
these pulsating laser lines up to a maximum distance of 30 m (RX 30) / 50 m
(RX 51 / 52). Minimum distance from the laser device about 3 m.
Now move the receiver field (B) of the laser receiver through the laser lines
upwards and downwards (horizontal laser line) and/or sideways (vertical laser
line) until the centre LED lights up. Now mark the horizontal and/or vertical
reference dimension.
RangeXtender RX 51
+
This button switches hand receiver
mode on and off.
This button is used to establish the
tolerance range.
This button is used to adjust the sensivity.
RangeXtender RX
RangeXtender RX 52
–
–
+
GB 07