Power Supply - Bosch WEU UniversalInspect Manual Original

OBJ_BUCH-3040-001.book Page 21 Monday, February 6, 2017 8:23 AM
Digital Inspection Camera
Display resolution
Operating time, approx.
Weight according to EPTA-Procedure 01:2014
(With batteries, without protective case, without ac-
cessories)
Dimensions (length x width x height)
Degree of protection of camera head and camera ca-
ble
Degree of protection of housing
1) Free of moisture condensation
The item number 15 on the type plate is used to clearly identify your inspection camera.
Assembly

Power Supply

The inspection camera can be operated with commercially available batteries.
To open the battery lid 17, press on the latch 16 and remove the battery lid. Insert the
batteries. When inserting, pay attention to the correct polarity according to the rep-
resentation on the inside of the battery compartment.
Always replace all batteries at the same time. Only use batteries from one brand and
with the identical capacity.
 Remove the batteries from the inspection camera when not using it for a pro-
longed period of time. The batteries can corrode and self-discharge during pro-
longed storage.
Note: The ribbon 20 in the battery compartment is used to conveniently remove the
batteries.
Charge Condition
In photo mode, the state of charge of the batteries is shown in the status bar whenev-
er a button is pressed. When the battery symbol is empty, you have to replace the bat-
teries because inspections are no longer possible.
Bosch Power Tools
English | 21
UniversalInspect
320 x 240
h 4
kg 0.39
mm 161 x 70 x 41
IP 67
–
1 609 92A 3HR | (6.2.17)