Max ULTIMATE VII Manual Del Usuario página 7

USER'S GUIDE DESKTOP NAIL DUST
COLLECTOR MAX ULTIMATE VII
General description
The MAX Ultimate VII nail dust collector is designed for use by professional
manicurists. It is used for removal of dust, which appears in the process of nail
filing and removal of artificial coatings.
Usage of the nail dust collector is recommended:
• during gel and acrylic nail extension, nail correction;
• while removing of gel polish and other artificial coatings;
• when performing manicure (especially hardware one).
Complete set
1. Dust collector with a filter bag installed.
2. Additional filter bag.
3. Passport.
Operational principles
The manicurist works in the dust collector fan grill area. The dust-air mixture is
sucked with the fan impeller of the dust collector. Clean air flows back into the
room after its filtration through the bag filter. Dust is collected inside the filter.
The manicurist cleans the filter bag after finishing.
Usage
1. Put the filter bag on the fan. The bag must be placed parallel to the side
panels of the device with a dart towards the body. Do it carefully. The filter
bag should be placed along the whole surface of the fan.
2. Place the device on a stable, flat surface. The side with the grill must be
facing you. Make sure that the bag is fixed evenly and does not fall under
the side panel of the device.
3. Before switching on, make sure that there are no foreign objects between
fan blades.
4. Insert the plug into a mains socket 220V. Use the switch located on the side
panel of the dust collector to turn it on and off. To adjust power, use the rpm
governor on the wire. After the first switching on, it is recommended to lift
the dust collector and make sure that the bag is puffed and nothing disrupts
the air flow. Procedure of switching on: turn the rpm governor clockwise
until it locks. Turn the switch to the ON position. Move the regulator
counterclockwise to control speed. In order to turn off the device, turn the
switch to the OFF position.
5. Work in the area of the dust collector fan impeller and approximately 1.5 cm
away from the edge of the grill to the center.
ENG
7