Sophos XGS 5500 Manual Del Usuario página 6

3. Power Up the Appliance
Connect the power cable and turn on the appliance
Connect the appliance to the power supply using the power cable(s). Turn the appliance on. The power
switch is on the back of the appliance next to the power connection. Once the appliance has booted
completely, you will hear an acoustic signal: five beeps in a row.
4. Connect Your Administration PC
Please note: We recommend that you use the MGMT interface to connect the Administration PC and all
other network interfaces for regular network traffic. Therefore, the following settings are for the MGMT
port only. However, if required, you can also connect your Admin PC to any other LAN port. Please make
sure that you use the correct IP address.
Administration PC connection properties:
Use the settings below to configure your (PC/laptop) network interface:
Ì IP address: 10.0.1.2
Ì Netmask: Enter 255.255.255.0
Ì Default Gateway: Enter the IP address of the appliance's internal network card (MGMT): 10.0.1.1
Ì DNS Server: Enable this option and enter the IP address of the internal network card (MGMT): 10.0.1.1
Connect your PC/laptop to the MGMT port of the appliance:
Start the browser and enter the IP address of the appliance's MGMT port that your PC is connected to:
https:/ /10.0.1.1:4444
Login with the default details below:
Username: admin
Password: admin
Quick Start Guide XGS 5500/6500
ENGLISH
Internet
e.g., DSL modem
2/WAN
XGS Appliance
MGMT
Switch
Internal network
admin client PC
5