Beckett GP210V Instrucciones De Funcionamiento

BECKETT SUBMERSIBLE PARTS WASHER PUMP
All GP pump models feature a unique manufacturing process that provides an extra margin of safety while protecting the environment.
Beckett GP pumps are non-oil filled pumps, and feature a completely encapsulated motor, which prevents any current leakage onto
electrical connections. The Beckett GP pumps are intended for use only in Underwriters Laboratories (UL) listed parts washers.

The Beckett GP210V & GP325V pumps are suitable for circulating stoddard solvents and aqueous cleaning solutions up to 110º F.
The use of any other liquid constitutes a special application and may void the warranty.

These pumps are thermally protected and they are designed for only submerged operation for proper cooling.

A conduit must be attached to the builder's fitting of the pump to protect the electrical cord. Failure to install a water tight conduit
may void the warranty.
CAUTION:
Do not let the pump operate dry.

All motors are pre-lubricated and no further oiling is needed.

To reduce the output flow, restrict the discharge of the pump, not the intake.

If the intake becomes clogged, remove screen and flush with clean water.
 Risk of electric shock –To reduce the risk of electric shock, be certain that the Pump is
connected only to a properly grounded, grounding-type receptacle.
 The electrical cord must be protected by a liquid tight conduit.
 Before servicing or handling pump, make sure the pump is disconnected from the power source.
 Do not connect unit to any other voltage than shown on the pump.
OPERATING INSTRUCTIONS
Models: GP210V & GP325V
INTRODUCTION
OPERATION
MAINTENANCE
WARNING!
92326
Rev.A