Enerpac VFC3 Hoja De Instrucciones

L-2385 Rev. 0
Index:
English ............................................page 1-3
Français ..........................................page 4-6
Deutsch ...........................................seite 7-9
Italiano..........................................pagina10-12
Español ........................................página13-15
Nederlands...................................pagina16-18
1.0 IMPORTANT RECEIVING
INSTRUCTIONS
Visually inspect all components for
shipping damage. Shipping damage is not
covered by warranty. If shipping damage is
found, notify carrier at once. The carrier is
responsible for all repair and replacement
costs resulting from damage in shipment.
SAFETY FIRST
2.0 SAFETY ISSUES
Read
warnings, and cautions
carefully. Follow all safety
precautions to avoid personal injury or
property damage during system operation.
Enerpac cannot
damage or injury resulting from unsafe
product use, lack of maintenance or
incorrect product and/or system operation.
Contact Enerpac when in doubt as to the
safety precautions and applications. To
protect your warranty, use only Enerpac
hydraulic oil.
Failure to comply with the following
cautions and warnings could cause
equipment damage and personal injury.
A CAUTION is used to indicate correct
operating or maintenance procedures and
practices to prevent damage to, or
destruction of equipment or other property.
A WARNING indicates a potential danger
that requires correct procedures or
practices to avoid personal injury.
®
12/98
all instructions,
be responsible
Instruction Sheet
VFC3 FLOW CONTROL
A DANGER is used only when your action
or lack of action may cause serious injury
or even death.
WARNING:
personal protective gear when
operating hydraulic equipment.
WARNING: Stay clear of loads
supported by hydraulics. A
cylinder, when used as a load
lifting device, should never be used as a
load holding device. After the load has
been raised or lowered, it must always
be blocked mechanically.
for
WARNING:
equipment
attempt to lift a load weighing
more than the capacity of the cylinder.
Overloading causes equipment failure
and possible personal injury. The
cylinders are designed for a max.
pressure of 350 bar. Do not connect a
jack or cylinder to a pump with a higher
pressure rating.
Never set the relief valve to a
higher
maximum rated pressure of the
pump. Higher settings may result in
equipment damage and/or personal
injury.
Wear
DANGER: To avoid personal
injury keep hands and feet
away from cylinder and
workpiece during operation.
Do not
ratings.
pressure
proper
exceed
Never
than the