Tabla de contenido
Publicidad
03
SETUP
04
AZIO
RETRO CLASSIC
Setting Up
The Retro Classic BT is a very versatile keyboard that supports both MAC/PC and can be
connected wirelessly via Bluetooth or wired via USB. The operating system selection and
interface mode switches are both located on the back side of the keyboard.
Pairing the Keyboard in Bluetooth Mode
1.
Switch the keyboard to BT mode. The mode switch is located on the back side of the
keyboard.
2.
Put the keyboard in Pairing Mode by holding down (FN) key and the ( - ) key on the
number pad. Hold down these two keys for a few seconds until the blue LED (Marked
"W") changes from a quick flash to a slow continuous flash. The keyboard is now in
Pairing Mode.
3.
On your Mac, navigate to 'System Preferences' and select 'Keyboard'. Next, click on
'Set Up Bluetooth Keyboard'. For Windows 10, go to Bluetooth Settings and select 'Add
Bluetooth or other device'.
4.
Once the setup wizard finds 'AZIO Retro Classic BT', click on 'Pair'.
5.
Once pairing is successfully completed, the blue flashing LED (Marked "W") will stop
flashing. The keyboard is now ready for use.
Publicidad
Tabla de contenido
