Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing
Use the unit with dry or slightly humid hair, but never with complete wet hair.
•
Use a conditioner after having washed your hair. Rinse and dry the hair well and comb it
•
out before styling. All this will make the styling easier.
Caution! Never use the appliance without the accessories. It is not suited for use without
accessories attached.
Connect the appliance to the current and set the switch to "1".or "2". The unit is now operating.
•
Apply it to dry or slightly humid hair, but never to wet one. Use the appliance when your hair is
•
slightly damp, never use it with completely wet hair. It is recommended to use a conditioner after
having the hair washed. This will allow easy styling. Rinse the hair after treatment well and let it
dry or blow dry the hair till it is slightly damp before styling it.
Comb your hair before styling it to untangle.
•
Do not use the appliance with synthetic hair or wigs.
•
To style the hair, do not wind too thick curls around the brush. Move the brush outwards first then
•
inwards curling the hair ends towards the head. Let the hot air act on the hair for a few seconds.
Then unroll the locks. To avoid burning keep the hot brush away from the scalp and skin, do
not touch hot parts of the appliance! Let the hair cool down before final combing.
Change of accessory
To remove an accessory, press the release button near the switch and pull the accessory off the unit.
The round brush is suited for styling and making curls
Setting the temperature level
Position 0 = off
Position 1 = medium temperature and air flow for drying and shaping
Position 2 = high temperature and air flow for fast drying
Position C = air for gentle drying and shaping (sensitive hair)
Notice: Always switch OFF and unplug electric devices after each use to avoid any risks of
electrical shock, short circuit, cable fire which can occure when units are plugged and not
supervised.
C
l
e
a
n
i
n
g
a
n
d
s
t
o
r
i
n
C
l
e
a
n
i
n
g
a
n
d
s
t
o
r
i
n
Caution! Danger of electrical shock! Never immerse the appliance, cord and plug into water!
The connector parts must not get wet. Contact of electrical parts with moisture causes short
circuit and damage. Before cleaning make sure that the unit is unplugged and has cooled
down completely.
Before cleaning always switch the appliance off and pull the plug.
•
Before cleaning and storing allow the appliance to cool down completely.
•
When necessary the housing can be wiped off with a dry soft cloth without any detergents.
•
Never clean sensitive surfaces with sharp-edged or metallic objects or sharp detergents.
•
Remove hair and lint from the attachment (after the unit has cooled down completely) after each use.
•
Do not wind the cable around the unit for storing as it might get damaged.
•
Store the appliance in a dry place and not reachable for chidren.
•
T
e
c
h
n
i
c
a
l
d
a
t
a
T
e
c
h
n
i
c
a
l
d
a
t
a
230V ~ 50 Hz, 400W, protection class II
The unit is tested according to GS and EMC regulations and is built to CE-regulations.
Additional protection may be obtained by fitting an earth-leakage circuit-breaker (IF=30mA) into your
home installation. Please consult a qualified electrician.
g
g
9
Publicidad
Capítulos
Tabla de contenido
