Maintenance And Adjustment - Domino SPI 60 Manual De Instrucciones

Be sure that machine voltage is the same as
that distributed by power mains (see rating
plate in machine rear, page 17).
For connection to electrical system, fit a sui-
table plug to the machine power supply
cable.
Warning: have the plug fitted to the
power supply by qualified person-
nel. Take the necessary precautions to
prevent the cable from being crimped
or damaged.
After positioning the machine in the prefer-
red location, adjust yhe knob to ensure per-
fect stability of the machine. Then tighten
their respective check nut.
After mating the plug to the mains socket,
the machine is ready for use.
First, however, check out proper operation
of all moving parts and components of the
machine. Thus, check:
• rotation direction of bowl (compare with
arrow on bowl) and spiral;
• safety device serviceability: device is
serviceable when machine stops the
moment the guard is lifted by 10-15 mm;
• operation of pushbuttons and pilot
lamp.
Important: If the machine or some of
its parts fail, call your local authori-
sed dealer or concessionaire for
repairs.
6. CLEANING
Warning: for healthy and
hygienic processing of nutri-
tional products, be sure to
keep your machine and the
surrounding
clean.
Always cut off power supply
before cleaning.
After use, especially since processed mate-
rial is still soft, always thoroughly clean
guard, bowl, spiral and column. Inspect and,
if necessary, clean the process tools again
before a fresh kneading operation.
Use hot water to remove and rinse off any
residual dough. Dry with nutritional absor-
bent paper and disinfect with a soft cloth
dabbed in alcohol.
To clean machine internal and external
parts:
• remove power supply plug from power
• clean coated surfaces with soft cloth and
• to clean internal parts of machine, first
To maintain machine safety, serviceability
and stated performance, service the fol-
lowing parts:
• Belt tension: once yearly, or in case of
environment
21
Warning: never use non-nutritional,
abrasive or corrosive chemicals to
clean. Also never use coarse or abra-
sive objects such as steel wool, abrasi-
ve sponges and so on.
mains socket;
disinfect with alcohol;
dismantle the panels (Fig. 3
remove any grease and powder from the
food products processed; then reassemble
the panels.

7. MAINTENANCE AND ADJUSTMENT

Warning: Remember that all mainte-
nance operations are hazardous if
you do not first disconnect the plug
from power mains.
irregular machine operation (r.p.m. loss),
check belts drive tension.
Disassemble machine panels ( 3
sure that the belts are taut enough and, if
necessary, turn screw and knobs (Fig. 3
) marked by the appropria-
and );
); be