Assembling The Lawnmower; Assembling The Handle; Installing The Wheels And Setting The Mowing Height - Fieldmann FZR 4005 BH Manual De Instrucciones

EN 8

Assembling the lawnmower

5. ASSEMBLING THE LAWNMOWER
IMPORTANT INFORMATION: Carefully unfold the lawnmower handle, being careful not to pinch or
damage the lawnmower's control cables.

5.1 ASSEMBLING THE HANDLE

1. Insert the bottom part of the handle (Fig. 2 – point 1) into the respective hole on the lawnmower (see arrow)
and secure in place with the 2 included screws – one screw with a washer on each side of the handle.
2. Attach the top part of the handle to the bottom part of the handle using the included screws with wing nuts
(Fig.2 – point 2).

5.2 INSTALLING THE WHEELS AND SETTING THE MOWING HEIGHT

Slide the threaded pin (Fig. 3, point 1) through the wheel
Select the required mowing height and screw the wheel into the appropriate hole (Fig 3, point 2+3)
A: 25mm, B: 40mm, C: 55mm
Put on the wheel cover (Fig. 3, point 4).
Repeat this procedure for all 4 wheels.
! Attention: The mowing height must be set the same on all wheels.
Fig. 2
2
Fig. 3
FZR 4005 BH