Publicidad
Idiomas disponibles
Idiomas disponibles
2
1. Disconnect the negative battery cable located in the
trunk near the spare tire.
2. Open the hood.
3. Lift the engine cover retaining grommets off the ball
studs and remove the engine cover (1).
4. Disconnect the electrical connector (1) from the Inlet
Air Temperature (IAT) Sensor.
5. Using a screwdriver, loosen the clamp (2) at the throt
tle body.
6. Using a screwdriver, loosen the clamp (3) at the air
cleaner housing.
7. Lift the air inlet hose assembly retaining grommet off
the ball stud (4).
8. Remove the air inlet hose assembly (5).
9. Disconnect the hose (1) from the air cleaner housing.
10. Using a 8mm socket/ratchet, remove the air cleaner
housing retaining bolt (2).
11. Remove the air cleaner housing (3).
Nov 10, 2010
K6861187
Publicidad
