1. Press ON/OFF then immediately press CLEAR + TARE/ENTER simultaneously
2. You will then see SET-1 on the LCD
3. Press TARE/ENTER again
You will then see SET-11
4. Press TARE/ENTER again
You will see CAL followed by a 5 digit number
5. Press ↓ (down arrow)
You will see "ZERO" appear on the bottom left side of the LCD momentarily
6. Place a known calibrated weight on the platform
The number on the LCD will change to a new 5 digit number
7. After the new five digits become stabilized, Press ↑ (UP arrow)
8. You will see the word "TARE" appear in the middle of the LCD for a moment
9. Press TARE/ENTER again and you will see GOOD
10. Press UNIT/SHIFT and in combination with the ↑ and ↓ (UP/DOWN arrow keys) set the proper
display that corresponds to the exact weight that is placed on the platform
11. When you have completed setting the display in agreement with the actual weight press
TARE/ENTER again and you will see GOOD followed by HELLO and the actual weight amount
will appear on the LCD again
12. Calibration is completed. Remove the weight from the platform and the scale should read 0.000
1 Aspen Drive • Randolph, NJ 07869 • phone (973) 252-9119 • fax (973) 252-2455 • www.mastercool.com
98210 – B1 CALIBRATION PROCEDURE
ELECTRONIC CHARGING SCALE
98210-B1-calibration