Dip-Switch Settings - Seneca K107A Manual Del Usuario

DIP-SWITCH SETTINGS

Both the K107 A and K107 B modules can be completely configured by dip-switches.
The meaning of the possible dip-switch settings is provided below.
In all the following tables, the indication
whenever no such indication is provided, it means that the DIP-switch is set in 0 (OFF).
X->Y DIRECTION INHIBITION
SW1 1
Enabled
Disabled
Y Terminator
SW1 2
Enabled
Disabled
Transmission speed
SW2 3 4 5
115200
57600
38400
19200
9600
4800
2400
1200
Y->X DIRECTION INHIBITION
SW1 6
Enabled
Disabled
X Terminator (only for the K107A)
SW1 7
Enabled
Disabled
Polarizer * (only for the RS232 of the K107 B)
SW1 8
Enabled
Disabled
* When installed, the polarizer prevents the RS232 line from capturing noise when left
disconnected
means that the DIP-switch is set in 1 (ON);