Intended Use; Technical Specifications - Roney Power RPV 20.0-2Li Manual De Instrucciones

Cordless drill/driver

INTENDED USE

This tool is intended for drilling in wood, metal, ceramic and plastic; tools
with electronic speed control and left/right rotation are also suitable for
screwdriving and thread cutting

TECHNICAL SPECIFICATIONS

PRODUCT ELEMENTS
1 Switch for on/off and speed control
2 Switch for changing direction of rotation
3 Keyless chuck
4 Ring for torque control
SAFETY
WARNING! Read all instructions. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
• Ensure the switch
Inserting the battery pack into power tools that have the switch on invites
accidents.
• Recharge only with the charger specified by the manufacturer. A charger that is
suitable for one type of battery pack may create a risk of fire when used with
another battery pack.
• Use power tools only with specifically designated battery packs. Use of any other
battery packs may create a risk of injury and fire.
• Avoid damage that can be caused by screws, nails and other elements in your
workpiece; remove them before you start working.
• Always check that the supply voltage is the same as the voltage indicated on
the name-plate of the charger (chargers with a rating of 230V or 240V can also
be connected to a 220V supply).
• In case of electrical or mechanical malfunction, immediately switch off the
tool or unplug charger from power source.
• RONEY POWER can assure flawless functioning of the tool only when original
accessories are used.
• Use only accessories with an allowable speed matching at least the highest no-
load speed of the tool.
• This tool is not a toy, which should not be used by people under the age of 16
years.
• Be careful not to drill or drive into areas where electrical wires may be
contacted.
• Ensure that switch is in the middle (locking) position before making any
adjustments or changing accessories as well as when carrying or storing the tool.
• Do not touch the contacts in the charger.
• Do not expose tool/charger/battery to rain.
• Never charge battery outdoors.
• Store tool/charger/battery in locations where temperature will not exceed 40° C
or drop below 0° C.
• Batteries will explode in fire, so do not burn battery for any reason.
• When damaged, and under extreme usage and temperature conditions, batteries may
start to leak.
- if liquid comes into contact with the skin, wash quickly with soap and water,
then with lemon juice or vinegar.
- if liquid gets into the eyes, flush eyes with clean water for a minimum of 10
is in the off position before inserting battery pack.
6