D-Link DAP-1360 Guía De Instalación Rápida página 6

TrOUbLEShOOTING
seTUP AND CONFiGUrATiON PrOBleMs
1. hOw DO I CONFIGUrE MY DAP-1360 wIrELESS N ACCESS POINT wIThOUT ThE
CD, Or ChECK MY wIrELESS NETwOrK NAME (SSID) AND wIrLESS ENCrYPTION
KEY?
- connect your pc to dap-1360 using an ethernet cable.
- open a web browser and enter the address http://dlinkap
- the default username is admin. the default password is blank (leave this box empty).
- If you have changed the password and cannot remember it, you will need to reset the product
to set the password back to default.
2. hOw DO I rESET MY DAP-1360 wIrELESS N ACCESS POINT TO FACTOrY DEFAULT
SETTINGS?
- ensure the product is powered on.
- press and hold the reset button on the rear of the device for 5 seconds.
Note: Resetting the product to the factory default will erase the current configuration settings.
to reconfigure your settings, log into the dap-1360 as outlined in question 1, then run the
setup Wizard.
3. hOw DO I ADD A NEw wIrELESS CLIENT Or PC IF I hAVE FOrGOTTEN MY
wIrELESS NETwOrK NAME (SSID) Or wIrELESS ENCrYPTION KEY?
- For every pc that needs to connect to the dap-1360 wirelessly, you will need to ensure you
use the correct Wireless network name (ssId) and encryption key.
- use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- make sure you write down these settings so that you can enter them into each wirelessly
connected pc. You will find a dedicated area on the back of this document to write down this
important information for future use.
4. whY CAN I NOT GET AN INTErNET CONNECTION?
- For cable users, make sure that the Clone MAC address option is ticked during Wizard
installation (or enter the registered mac) and that your Isp username and password is correct.
4
DAP-1360