Switching On And Off - Monti BLASTER Manual Del Usuario

®
BRISTLE BLASTER ELECTRIC DOUBLE
e) To stop the tool, simply release the pressure on the Safety Switch.
When plugging in, ensure the Safety Switch is not activated (Figure 9).
Figure 9
f) Hold the tool by the tool body and the vertical handle simltaneously.
g) To obtain the best performance, ensure the Accelerator Bar is maintained
approximalely 10mm from the work surface. If the Accelerator Bar is too far from
the surface, the performance will drop significantly. See Figure 4. For a more
detailed description of the function of the Bristle Blaster
www.montipower.com.
h) Always work with appropriate contact pressure. Excessive contact pressure will
limit the performance and cause damage to the MontiPower
and tooth belt.
7. Use
7.1 Setting speed
The rotating speed is preset and fixed at 2,400 rpm to ensure optimal performance.
The VTC electronics make material-compatible work possible and an almost constant
speed, even under load.
7.2

Switching On and Off

Always guide the machine with both hands.
Switch on first, then guide the accessory towards the workpiece.
The machine must not be allowed to draw in additional dust and shavings.
When switching the machine on and off, keep it away from dust deposits. After
switching off the machine, only place it down when the motor has come to a
standstill.
®
visit
®
Bristle Blaster
EN
®
Belt
11