Princess 332860 Manual De Instrucciones página 14

Assembly
Warning!
­ Before assembly, always remove the
mains plug from the wall socket.
Mounting and removing the
dustbag (fig. B - D)
The dustbag and the dustbag holder must be
properly mounted in order to close the cover
of the dustbag compartment.
Warning!
­ Do not use the appliance without the
dustbag.
Mounting the dustbag
• Keep the release button (16) pressed and
open the cover (17).
• Remove the dustbag holder (19) from the
dustbag compartment (6).
• Insert the dustbag (20) into the slots (21) of
the dustbag holder (19) (fig. C1). Slide the
dustbag (20) to the end of the dustbag
holder (19) (fig. C2).
• Insert the dustbag holder (19) into the slot
(22) of the dustbag compartment (6) (fig.
D1). Push the dustbag holder (19) until the
dustbag (20) is locked by the dustbag lock
(24) (fig. D2).
• Close the cover (17) until the release
button (16) clicks into place. Make sure
that the hole (23) in the dustbag (20) aligns
with the hose connection (18).
Removing the dustbag
• Keep the release button (16) pressed and
open the cover (17).
• Remove the dustbag holder (19) from the
dustbag compartment (6).
• Remove the dustbag (20) from the dustbag
holder (19).
• Insert the dustbag holder (19) into the slot
(22) of the dustbag compartment (6).
• Close the cover (17) until the release
button (16) clicks into place.
Mounting the hose, the tube and
the suction nozzle (fig. E - G)
• To mount the hose (7), insert the hose
outlet (25) into the hose connection (18)
until the release buttons (26) click into
place.
• To mount the tube (8), insert the tube outlet
(28) into the hose inlet (27).
• To mount the extension tube (9), insert the
tube outlet (30) into the tube inlet (29).
• To mount the suction nozzle (11), insert the
tube inlet (31) into the tube connection (32).
Mounting the crevice nozzle
(fig. F & G)
The crevice nozzle (15) can be used for
vacuuming in narrow and hard­to­reach places.
• To mount the crevice nozzle to the hose
(7), insert the hose inlet (27) into the
crevice nozzle (15).
• To mount the crevice nozzle to the tube (8),
insert the tube inlet (29) into the crevice
nozzle (15).
• To mount the crevice nozzle to the
extension tube (9), insert the tube inlet (31)
into the crevice nozzle (15).
Use
Unwinding and rewinding the
mains cable (fig. A)
The mains cable rewind button (2) can be
operated by hand or foot.
Caution!
­ Do not unwind or rewind the mains cable
while the appliance is switched on.
­ Always hold the mains plug to unwind the
mains cable. Never pull the mains cable.
• Before use, hold the mains plug and
unwind a sufficient length of the mains
cable from the back of the appliance.
• After use, press the mains cable rewind
button (2) to rewind the mains cable back
into the appliance. Manually guide the
mains cable to make sure that it does not
swing back. Make sure that the mains plug
is correctly located.
14