Descargar Imprimir esta página

Imiola HAK-POL B/009 Manual De Instrucciones página 5

Publicidad

• Odkręcić zderzak.
• Odkręcić wzmocnienie zderzaka (nie będzie już montowane).
• Przyłożyć belkę haka A do tylnego pasa i skręcić nakrętkami M12 poprzez otwory (pkt 1).
• Zamontować zderzak.
• Przykręcić kulę i blachę gniazda elektrycznego śrubami M12x70 8.8 (pkt 2).
• Dokręcić wszystkie śruby z momentem jak w tabeli.
• Podłączyć instalację elektryczną.
• Unscrew the bumper.
• Unscrew the reinforcement of the bumper (it will not be used any more).
• Put the main bar A to the rear belt and screw with nuts M12 through the holes (point 1).
• Assemble the bumper.
• Fix the ball and electric plate with bolts M12x70 8.8 (point 2).
• Tighten all the bolts according to the torque setting- see the table.
• Connect the electric wires.
Dévisser le pare-chocs.
Dévisser le renforcement du pare- chocs (il ne sera plus monté).
Mettre la poutre du crochet d'attelage A à la bande postérieure et serrer avec les écrous M12
en utilisant les trous adéquats (point 1).
Monter le pare-chocs.
Visser le crochet d'attelage et socle de prise électrique à l'aide des boulons M12x70 8.8 (point 2).
Serrer tous les boulons avec un couple de serrage selon tableau.
Raccorder le circuit électrique.
• Die Stoßstange abschrauben.
• Die Stoßstange Verstärkung abschrauben, wird nicht wieder montiert.
• Den Querbalken A an den hinteren Karosseriestreifen anlegen und mit den Muttern M12
durch die Önungen (Punkt 1) anschrauben.
• Die Stoßstange montieren.
• Die Kugel und die Steckdosenhalterung mit den Schrauben M12x70 8.8 (Punkt 2) anschrauben.
• Alle Schrauben mit dem in der Tabelle angegebenem Drehmoment anschrauben.
• Die Elektroinstallation anschließen.
Desenroscar el parachoques.
ź
Desenroscar el realzar del parachoques (ya no se montará).
ź
Colocar la barra del gancho A al latón trasero y apretar con las tuercas M12a través de los
ź
orificios (punto 1).
Instalar el parachoques.
ź
Apretar la bola y la placa de la toma de corriente tornillos M12x70 8.8. (p. 2).
ź
Apretar todos los tornillos con el par según la tabla anterior.
ź
Conectar la instalación eléctrica..
ź
ź

Publicidad

loading